It takes a 1-1/8″ socket.
Does a 6.7 Cummins have 2 fuel filters?
Product Description. Factory replacement front and rear fuel filter for 6.7 Liter Cummins Turbo Diesel engines. The 6.7L diesel engines require two fuel filters, one in the front engine compartment and another in the rear by the fuel tank.
How do you prime a 6.7 Cummins after a fuel filter change?
Bump the starter and leave the key in the on position to allow the electric lift pump cycle on 1998 and later 24v Cummins engines. The lift pump will cycle for about 30 seconds, refill the fuel canister, and prime the system. Repeat this process three or four times to assure adequate purging of the system.
How many fuel filters does a 2020 6.7 Cummins have?
NOTE: All 2019 to 2023 Dodge Ram 6.7L Cummins diesel trucks now contain two separate diesel fuel filters.
How do you reset the fuel filter on a 2019 Ram 2500?
What are the steps for resetting the fuel filter indicator? On the fuel filter life indicator screen, hold right arrow button, it will then give you option to down arrow to select reset, then push and quickly release right arrow for reset.
Does 2010 6.7 Cummins have 2 fuel filters?
You only have one filter, in the engine bay Drivers side.
Does 6.7 Cummins have water separator?
This Cummins 6.7L Fuel Filter is the diesel water separator filter installed in the 2013 to 2018 model dodge ram trucks. This diesel fuel water separator filter is located in the rear of the truck next to the diesel fuel tanks.
How often should you change fuel filters on a diesel truck?
For most Diesel trucks it is recommended that you replace your fuel filter every 10,000-25,000 miles depending on how you drive, how often you commute and what type of vehicle it is. Most cars will have information on how frequent you should change the fuel filter in the owner’s/maintenance manual.
How do you start a diesel truck after changing the fuel filter?
In some diesel engines, priming the fuel pump can be as simple as turning the ignition key to “run” for several seconds, turning off, and then repeating up to four times. This restart procedure will most likely be recommended by your manufacturer and allow you to restart the engine after a few minutes.
How do I start my 6.7 Cummins after running out of fuel?
(1) Cycle the key four times @ 15 seconds each. (2) Start the engine. (2a) If engine does not start, repeat step 1. (3) Engine will idle rough for 2-3 minutes.
