Bender Board is a plastic edging product for landscaping and concrete forming. Bender Board is manufactured from 100% recycled plastic, and will not decompose or rot. Bender Board excels as a forming board for concrete, for the installation of artificial turf and even as a fence.
What can I use instead of a bender board?
Installation tip: Like plastic bender board, metal edging comes in long strips and in similar lengths, heights, widths, and colors. It’s either made of heavy-gauge aluminum, which does not rust, or weather-resistant steel.
Can I use bender board for concrete forms?
It can be used for curving concrete sidewalk forms as well as temporary landscape applications.
Does edging prevent drainage?
Improperly installed edging can cause as many problems as it solves, however. The wrong technique could cause drainage problems, drowning the roots of bedding plants and trees and creating muddy, unattractive areas in the landscape.
Is metal edging better than plastic?
Plastic is the most commonly used edging material because it is very inexpensive and easy to install. Metal, on the other hand, is most the most commonly recommended edging material by professional landscapers.
Is metal edging better?
Metal landscape edging is the preferred choice of edging material by many professional landscapers. Likely, this is because metal in general, is sturdy, elegant, and timeless. Metal edging also offers a very clean-cut and practical resolution to keep plants and materials in place, while keeping grass and weeds out.
How many stakes should a bender board have?
Bender Board 12″ Stake – (Curved Areas requires 6, Straight Areas requires 10 per 20 ft Board) Typically add 6 stakes for curved project and 10 stakes for straight lines.
How do you bend plastic lawn edging?
If you want to make the plastic easier to bend, you can roll a piece over a large barrel so it has a natural bend before you place it in the trench. Try to use only single pieces along curves rather than joining two separate pieces because the joints become more noticeable along curves and at corners.
How do I bend a board?
All you need is a table saw, circular saw, or radial arm saw. To bend wood with kerf cuts, adjust the saw blade so that it will cut all but the last ⅛- to 3/16-inch of material. Then, make cut kerfs across the board every ½ inch or so (keep these cuts evenly spaced for best results).
