Mower deck gauge wheels should be properly adjusted to prevent scalping grass on uneven terrain. The bottom of the wheels should sit approximately 1/8-1/2 of an inch from the ground, depending on your cutting height.
How do I raise my mower deck?
Turn the adjusting lock nut clockwise to raise the mower and counterclockwise to lower it. Measure from the blade to the ground again on both sides and adjust until the difference between the blade tip heights are within ⅛ -inch. Rotate the blades so that their direction is now front to back.
How do you level a craftsman cutting deck?
How to Level a Craftsman Lawn Mower Deck
Set the parking brake on the mower and move the engagement lever to the “Disengage” position. Pull the spark plug wire from the spark plug.Move the deck lift lever to the highest position, and then check the tire pressure. Put on gloves and safety glasses.
What are the height settings Craftsman mower?
How to Adjust the Height on a Sears Craftsman Mower
Locate the adjuster on one wheel. Move the lever from the notch it’s in by pulling the lever toward the wheel. Repeat this process for the other three wheels.Double-check that all four wheels have been set at the same height after you’ve finished adjusting them.
Is a mower deck supposed to be level?
Level the mower deck to ensure grass cutting height is even across the width of the deck. This will help ensure a smooth and seamless side-by-side blend between each row of freshly cut grass.
Should a mower deck be level front to back?
Leveling a lawn mower deck is done the same way as pitching a mower deck, except it’s adjusting the deck height from side to side, not back to front.
Why does my Craftsman riding mower cut uneven?
Sharpening or replacing the mower blades is also the answer if grass tips look ragged or tattered instead of cleanly cut. Blade vibration also causes an uneven cut. To eliminate vibration, replace unbalanced blades and worn mandrels. Replace a worn blade belt because a worn belt won’t spin the blades correctly.
How high should anti scalp wheels be set?
Mower deck scalp wheels should always be set 1/4″ off a HARD DECK surface. Place your lawn mower on a flat hard surface. Set your mower cutting height.
How do you raise the height of a lawn mower?
In order to increase your lawn mower height, adjust the lever next to each wheel one notch towards the rear of the mower. Move the lever as many notches to the correct cutting height you desire. If you move the lever towards the front of the mower, you will lower the lawn mower height.
