Cut 1/2 inch from the end of the molding at a 90-degree angle with a coping saw or a miter saw. This gives you the clean, sharp edge needed on the profile that enables you to cope it with precision.
What is cove trim?
Also known as coving, cove molding is plain, concave-shaped trim employed where walls and ceilings meet. It can also be used on stairs, at the meeting of risers and treads. In essence, cove may be considered a less ornate version of crown.
Can you cope cove molding?
But many inexperienced do-it-yourself enthusiasts have difficulty making concave cove molding fit neatly with adjoining miter cuts. The solution is using a coping saw to fit one end of a piece against the face of the adjoining piece. This saves time and improves the uniformity of inside corners.
Is there a top and bottom to cove molding?
The deeper grooves go on the bottom, and shallower grooves belong on the top. Generally, crown moulding extends further down the wall than on the ceiling. The concave (cove) side goes down, and the convex (rounded) side goes up.
Why does crown molding have to be cut upside down?
Chris Marshall: Crown molding is typically cut upside down on a miter saw so the narrow edge that will rest against the wall butts against the saw fence and the top edge of the molding that will meet the ceiling rests on the saw table.
What is 31.6 on a miter saw?
Tilting and rotating a miter saw allows you to make a right-angle joint with a wide piece of crown molding. Many saws have a detent at 31.6 degrees for making this cut. PHOTO 4: Saws with tall fences and stops are best for cutting crown molding in an upright position.
