Resin is an important part of any water softener tank. Most resins do not need to be replaced frequently, but the frequency of the softener’s regeneration cycle affects the life of the resin.
How long does a water softener resin tank last?
How Long Does Water Softener Resin Last? Common sense would indicate that the resin beads can only be regenerated so many times before they lose their effectiveness. Lucky for you, that typically doesn’t happen for about 20 years, which is the typical lifespan of a water softener anyway.
How do I know if my water softener resin is bad?
How do you know if your resin bed has “checked out”? Simple. Check to see if your water softener is using up salt at its regular rate. If it is, and you have no soft water, the resin bed has probably become saturated with iron deposits or been damaged by chlorine and can no longer be regenerated by the brine.
How do I clean my water softener resin?
There are two ways to clean the tank: The first is to unplug the water softener unit and remove the resin tank by unscrewing the bolts and disconnecting the valve. You can then clean the tank using bleach and water before reinstalling the tank.
Is all water softener resin the same?
Not all water softener resin is the same. WaterBoss uses “fine mesh” resin, which is much smaller, so more beads are tightly packed into the bed compared to ordinary resins.
How long do resin beads last?
Resin beads in water softeners typically last about 10 to 15 years. However, they can be damaged by the excessive amounts of chlorine that are found in city water or iron in well water.
What is the black stuff in my water softener?
If you notice dark stains near the water line in the brine (salt) tank, you should clean it now! Those dark stains are mold. You don’t want mold, fungi, or bacteria to thrive in your water softener.
How much resin should a water softener have?
Depending on its size, the amount of resin should be anywhere from 0.64 to 2.00 cubic feet. When you get the amount right, you eliminate one potential source of water softener problem.
What causes resin to come out of water softener?
A broken screen or failed seal in the upper distributor can allow water softener resin beads to escape into the water supply. A cracked upper distributor also can cause this problem. Unplug the water softener and shut off the water supply, then remove the valve assembly and inspect the upper distributor components.
Why is resin coming out of water softener?
Water softeners use resin beads to remove minerals from hard water through ion exchange. Normally, a screen keeps the beads from entering your water filters and plumbing system. However, if the screen gets torn, beads can end up getting lodged in the aerator.
