Solved! What to Do When Your Snow Blower Won’t Start
Make sure all switches and valves are in the correct starting position.Drain and replace old gas in the tank.Add fuel stabilizer to the gas tank.Prime the engine to force fuel into the carburetor.Clean or replace the spark plugs.Examine the fuel line for damage.
Why does my snowblower not start?
A common issue is a clogged carburetor from stale gas. Using a fuel stabilizer keeps fuel fresh and the carburetor from gumming and varnishing. Third step, check the ignition system with a spark tester. Step four, replace the spark plug and reconnect the spark plug wire.
When should I start snow blowing?
Start Before Snow Buildup Reaches 6 Inches
Sometimes, it’s best to start snow blowing while the flakes are continuing to fall. If possible, start up the task before the snow hits 6 inches. Sure, it will take more time to clear it away.
How do I know if my snowblower is flooded?
How do I know if my snowblower is flooded? You know your snowblower is flooded if you notice gas on the spark plug tip. This is a telltale sign of a flood. Your snowblower will also have a strong smell of fresh fuel and make a whirring sound when you try to start it.
What happens if you prime a snowblower too much?
In a nutshell, the engine gets fuel from the fuel lines to the carburetor when it rations. You shouldn’t use it twice because our Toro snowblower recommends pressing the primer. Our research has found that it actually needs more like 8-10 pumps just to work. The over-prime of the engine will cause it to flood, however.
Why is my snowblower not getting spark?
The most common cause of a snowblower without spark is a fouled spark plug. Cleaning and gapping or replacing the spark plug will fix the problem. Other likely causes of snowblower no spark, include: Faulty control switch (on/off switch)
Where is the spark plug on a snowblower?
The spark plug on your snow blower should be easy to locate. It’s usually right on the top of the unit or under a cover. A spark plug is connected to the engine by the wire from the ignition system. It’s a necessary part to check when servicing your snow blower.
