How to Program Your Hunter X-Core Sprinkler System
Step 1: Set The Current Time. First, you will want to ensure that the current time is correct. Step 2: Set the Start Times. Next, turn the dial to “Start Times”. Step 3: Set the Run Time. Step 4: Set the Watering Days. Step 5: Test Coverage. Step 6: Finished!
Why does my Hunter Pro C sprinkler system keep running?
Pro-C – Station Repeats A common reason for a controller to repeat a cycle is too many programmed start times. Only one start time per active program is required, a second start time will cycle the program an additional time. NOTE: In the Start Times dial position, the numbers 1-4 do not represent stations.
How do I start Hunter Pro C in Spring?
Spring Start-Up Checklist
Open the system main water valve slowly to allow pipes to fill with water gradually. Verify the proper operation of each station valve by manually activating all zones from the controller.Walk through each station on the controller, checking for proper operation of the zone.
Why is my Hunter irrigation system not working?
The most common reason your sprinklers are not watering is because the rain sensor is active. Do you have a rain sensor on your sprinkler system? If so, slide your sensor bypass switch into the “BYPASS” position (on an SRC, turn the dial into the RUN (Bypass Sensor position).
How do you test a hunter sprinkler system?
To initiate the test program:
Press and hold the PRG button. The station number will be flashing.Press the or button to scroll to the station you would like the test program to start with. Use the and buttons to set a run time of up to 15 minutes. After a 2 second pause, the test program will begin.
Why does my irrigation system finish watering and then start again?
A common reason why a program is repeating is that you have a second start time set. The start times control the exact time your ESP-Me timer will begin to water and they also control how many times a day your timer will water. The ESP-Me allows you to set up to 6 start times per program.
Where is the reset button on a Hunter thermostat?
Press and release the RESET button on the back of the front panel.
How do I know if my sprinkler controller is bad?
Sprinkler System Troubleshooting — 5 Signs Of A Faulty System
Controller Isn’t Working Properly.Low or High Water Pressure.Sprinkler is Stuck or Won’t Come Up.Puddles on Lawn or Around Sprinkler.Uneven Spray Patterns.When to Call a Professional.
Can I turn on my sprinkler system myself?
Some homeowners count on a lawn service or irrigation contractor to winterize the system in the fall and turn it back on in the spring, but there is no reason to pay for this service, as it’s very easy to do yourself in just a matter of minutes.
