One coat is enough, but if more color is desired, a second coat can be applied within two hours before the first coat has dried. With Thompson’s® WaterSeal® Waterproofing Stains, you can clean your tools with soap and water. Let the deck dry for at least 24 hours and you’re ready to replace the furniture.
How long does Thompson’s water Seal take to cure?
Allow at least 24 hours to dry; however drying time will vary depending on the substrate, temperature, and humidity. When completely dry, perform the splash test to determine if second coat is necessary. Allow 45 days drying time before applying latex paint over Thompson’s® WaterSeal® Clear Multi-Surface Waterproofer.
Is Thompson’s water Seal waterproof?
Wood sealer that provides long-lasting outdoor wood protection. It waterproofs long after the initial water beading is gone.
What is Thompson’s water Seal used for?
Thompson’s® WaterSeal® Penetrating Timber Oil is an oil-based product that provides protection by penetrating into wood pores and sealing out water infiltration. Thompson’s® WaterSeal® Waterproofing Stains are water-based products that have film-forming properties to protect the wood by repelling water.
Can you put Thompson water seal on treated wood?
Other products, like Thompson’s® WaterSeal® Waterproofing Stain, can be applied immediately to new pressure treated lumber. New cedar and redwood can always be treated immediately.
What is the best way to apply water seal?
The fastest way to apply is with a pump-up sprayer (using a coarse setting), but you can also apply with a brush or a roller. You should apply liberally. In the case of areas with heavy discoloration or dirt, apply a second coat, brush lightly with a broom and hose off.
When can you walk on Thompson Water Seal?
How long before you can walk on Thompson Water Seal? Surfaces coated with Thompson’s water seal should be dry in about 24 hours. That is all the time you need to wait before you can walk on the sealed surface if you followed the application instructions correctly.
Can you use a pump sprayer to apply Thompson’s water Seal?
Yes, you can apply your Thompson’s water seal using a standard pump garden sprayer and achieve the desired results. This sprayer is best to use when applying sealers.
How much does a gallon of Thompson’s water Seal cover?
That determines how many gallons of stain are required (each gallon covers up to 400 square feet). You can buy it and be on your way. Thanks to its pigment-suspension technology, there’s no need to wait for the Waterpoofing Stain to have its turn in the paint shaker.
Can you use Thompson water Seal on pavers?
Provides proven waterproofing protection for all masonry surfaces including pavers, brick, concrete, stone, stucco, clay and quarry tile. Use for concrete waterproofing and as a brick sealer.
Can I paint over Thompson water Seal?
Can You Paint Over A Sealer? Water sealers can be painted, but the drying time of the sealer is the most important factor. If you are applying a finishing coat, you should use either latex-based or oil-based primer as your first coat.
Does Thompson’s water Seal peel?
– As far as we can tell, Thompson’s® WaterSeal® does not prevent UV graying at all. This is a huge disappointment as preventing UV graying is the number one reason to stain your exterior wood and decking. – Thompson’s® WaterSeal® penetrates deep into the wood. There was no peeling or wearing.
